DEVICE: Sonoma Orthopedic Products, Inc (00816988011446)

A hand-held tubular surgical device designed to simultaneously place, angle, and guide a rotating surgical drill on hard tissue (e.g., bone), and to protect the surrounding soft tissue while the drill is in operation. It may have serrations at its distal end to enable firm placement on hard tissue surfaces (it is not bored into the tissue); it can have a handle at its proximal end for holding and manipulation, or it may be held by another device (e.g., orthopaedic jig). The device is typically dedicated to drill bit size, made of metal, and may have graduations along its length; it is not custom-made for a specific patient. This is a single-use device.

A wire intended for the fixation of bone fractures that may be implanted or used short-term (e.g., to hold a plate in the correct position during an intervention). It may be used: 1) as a cerclage wire to aid bone fixation; 2) in a loop or figure-of-eight configuration to reattach, e.g., the tip of the elbow (olecranon), tibial tubercle, or greater trochanter; 3) to augment bone screw/plate fixation; or 4) as a Kirschner wire or K-Wire to stiffen (arthrodese) a toe or finger. It is made of metal [e.g., stainless steel, cobalt-chrome (Co-Cr)], and may be malleable or rigid; some types include a nut designed to be attached to the wire to prevent wire migration. This is a single-use device.

A metal shaft intended to be mounted into an appropriate surgical power tool (e.g., a pneumatic reamer or drilling system handpiece with appropriate torque capacity) and rotated to bore into hard/tough tissues (e.g., bone, cartilage) in order to clear a channel of the same diameter as the shaft, typically for the insertion of a prosthetic device or other orthopaedic implant. It has a hollow centre so it can be fed over a drill guiding pin, and may be flexible; devices to assist the procedure (e.g., drill guiding pin, manual driver) may be included. This is a single-use device.